Αριθμός ανταλλακτικού
Αποστρατιωτικοποίηση
Διάρκεια ζωής
UOM
NIIN
Αριθμός ανταλλακτικού:
482371j20
NSN
Εθνικός αριθμός αποθέματος:
TXT
Περιγραφή:
Plain Encased Seal
Κωδικός ονόματος στοιχείου:
04214
MRC:
A value which expresses the degree of heat or cold as applied to the operation,or limitation of operation,of an item.ABJH
Tempurature Rating:
-65.0 degrees fahrenheit and 300.0 degrees fahrenheit
MRC:
The length of a straight line which passes through the center of the accommodation for the shaft,and terminates at the circumference.ABVM
Accommodated Shaft Diameter:
Between 0.9100 inches and 0.9108 inches
MRC:
A measurement taken between the flat surfaces /front and back/ of the seal,in distinction from thickness.ADUC
Seal Width:
Between 0.297 inches and 0.327 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the case.BHHL
Case Style:
Square
MRC:
The length of a straight line which passes through the center of a circular housing bore,and terminates at the circumference.CPCW
Housing Bore Diameter:
Between 1.624 inches and 1.626 inches
MRC:
The style designation indicating the configuration that most nearly corresponds to the appearance of the sealing element.CTQC
Sealing Element Style:
Angular
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Rubber synthetic sealing element
MRC:
The chemical compound or mechanical mixture properties of which the item is fabricated.MATT
Material:
Steel case
MRC:
The specification,standard,drawing,or similar instrument that specifies environmental and performance requirements or test conditions under which an item is tested and establishes acceptable limits within which the item must conform identified by an alphabetic and/or numeric reference number. includes the commercial and government entity (cage) code of the entity controlling the instrument.TEST
Test Data Document:
02731-369a5419 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)
