Αριθμός ανταλλακτικού
Αποστρατιωτικοποίηση
Διάρκεια ζωής
UOM
NIIN
Αριθμός ανταλλακτικού:
tih-030m
Αποστρατιωτικοποίηση:
Yes - DEMIL/MLI
Πληροφορίες ανταλλακτικού
Induction heater
NSN
Εθνικός αριθμός αποθέματος:
TXT
Περιγραφή:
Aircraft Engine Maintenan Heater
Κωδικός ονόματος στοιχείου:
42577
MRC:
The dimension measured along the longitudinal axis with terminated points at the extreme ends of the item.ABHP
Overall Length:
7.900 inches
MRC:
The distance measured in a straight line from the bottom to the top of an item.ABKW
Overall Height:
10.200 inches
MRC:
An overall measurement taken at right angles to the length of an item,in distinction from thickness.ABMK
Overall Width:
18.100 inches
MRC:
The national stock number or the identification information of the end equipment for which the item is a part.AGAV
End Application:
F-119 engine
MRC:
An indication of whether or not a heating element is included.BWQH
Heating Element:
Included
MRC:
The master requirement codes of those requirements which are technically critical by reason of tolerance,fit,performance,or other characteristics which affect identification of the item.CRTL
Criticality Code Justification:
Agav
MRC:
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.FEAT
Special Features:
Temp control 0-250 degrees c; probe thermocouple, k type; probe maximum temp 250 degrees c; coil diameter 95 mm (3.7in) for min bearing bore diameter 100 mm (3.9in); workpiece maximum weight 40kg (88lbs); maximum heating temp 400 degrees c (752 degrees f); 3 standard yokes for min bearing diameter of 2.6in, 1.6 in, .8 in (65mm, 40mm, 20mm); remote control panel; inductive coil; folding bearing supports; yoke storage
MRC:
The cycles per second /hertz/ of the alternating current.FREQ
Frequency In Hertz:
60.0
MRC:
Describes the capabilities,intended use,and/or purpose for which the item is provided.FTLD
Functional Description:
Designed to heat bearings that are mounted with an interface fit onto a shaft. The heat causes the bearing to expand which eliminates the neeed to use force during installation. Designed to heat rolling bearings, however other workpieces that form a closed circuit can also be heated